2-48
FOR SAFE DRIVING
69TB-01E
2) Hook the top tether strap to the top
tether anchorage and tighten the top
tether strap according to the instruc-
tions provided by the child restraint sys-
tem manufacturer. Attach the top tether
strap to the corresponding top tether
anchorage located directly behind the
child restraint. Do not attach the top
tether strap to the luggage restraint
loops (if equipped).
52RS20431
3) When routing the top tether strap, pass
the top tether strap as shown in the
illustration. (Refer to “Head restraints”
(P.2-11) for details on how to adjust the
height of head restraint or remove it.)
4) Check that cargo does not interfere
with routing of the top tether strap.
5) Make sure the child seat is installed
properly according to the instructions
provided by the child restraint system
manufacturer.
•If the child restraint system is not
installed properly, consult the retailer
where you purchased the child
restraint system.
NOTE:
For Australian model, refer to “For Austra-
lia” (P.13-1).
WARNING
Do not attach the child restraint top
tether strap to the luggage restraint
loops. Incorrectly attached top tether
strap will reduce the intended effec-
tiveness of the child restraint system.
WARNING
If the seat belt, etc. gets stuck in the
child restraint system, it may not be
secured properly and this may cause
severe injury to a child in a collision.
When you install the child restraint
system, check that obstacles and the
seat belt do not exist near the ISOFIX
anchorages and the top tether
anchorages.
To Next Page
Loading...
Need help?
General
