3-57
5. At the same time that the chain is
being adjusted, the rear sprocket
must be kept in perfect alignment
with the front sprocket. To assist you
in performing this procedure, there
are reference marks
4 on the swing-
arm and each chain adjuster which
are to be aligned with each other
and to be used as a reference from
one side to the other.
6. Tighten the axle nut
1 securely.
7. Recheck the chain slack after tight-
ening and readjust if necessary.
8. Tighten the right and left lock nuts
2.
Rear axle nut tightening torque:
72.5 lbf-ft (100 N·m, 10.0 kgf-m)
NOTE: Do not adjust the drive chain
beyond the adjustable range
4.
Replace the drive chain before the drive
chain exceeds the limit.
To Next Page
Loading...
