3-66
REAR BRAKE PEDAL ADJUSTMENT
The rear brake pedal position must be
properly adjusted at all times or the disk
brake pads will rub against the disk
causing damage to the pads and to the
disk surface.
Adjust the brake pedal position in the
following manner:
1. Loosen the lock nut
1, and turn the
push rod
2 to locate the pedal 0.8 –
1.2 in (20 – 30 mm) below the top
face of the footrest.
0.8 – 1.2 in (20 – 30 mm)
WARNING
If you ride this motorcycle after brake
system repair or brake pad replace-
ment without pumping the brake
lever/pedal, you may get poor brak-
ing performance, which could result
in a crash.
After brake system repair or brake
pad replacement, pump the brake
lever/pedal several times until brake
pads are pressed against the brake
disks and proper lever/pedal stroke
and firm feel are restored.
To Next Page
Loading...
