Suzuki VZR1800 - CLUTCH INSPECTION

VZR1800/ZL0 (’10-MODEL) 7
CLUTCH
CONSTRUCTION
2.3 mm
(0.09 in)
3.4 mm (0.13 in)
2.9 mm (0.11 in)
3.0 mm (0.12 in)
2.0 mm (0.08 in)
t
a Driven plate No. 1 b Driven plate No. 2B Drive plate No. 2, 3, 4
A Drive plate No. 1
DRIVE PLATE:
Drive plate No. 1 ...........6 pcs.
Drive plate No. 2
Drive plate No. 3
Drive plate No. 4
Spring washer
Spring washer seat
DRIVEN PLATE:
Driven plate No. 1 ...........5 pcs.
Driven plate No. 2 ...........2 pcs.
()
.......Any 1 pc.
*
T
No. 2
2.0 mm (0.08 in)
2.3 mm (0.09 in)
1.6 mm (0.06 in)
No. 3
No. 4
t
NOTE:
* Basically in this motorcycle, the drive plate No. 2 is
installed as shown B. Instead of the No. 2, however,
sometimes the drive plate No. 3 or No. 4 may have been
installed at the factory for the purpose of fine adjusting
the overall thickness T of clutch plates.
When replacing the plate B in the aftermarket, always
use the drive plate No. 2.