Suzumar DS-360 - DS-225 SL Assembly

2
2.2.5 If the boat has been inflated in last 6 months, attach foot pump to each
valve, one at a time, and add air to each chamber to ½ of their capacity.
Then continue assembling the boat as followings:
2.3 Assembly for DS-225SL
bar
D S - 2 2 5 S L
bar
bar
2-1
2.3.1 Before inflating the boat, make sure the wooden slats are in the middle
of bottom; Install the wooden seat.
2.3.2 Inflate each chamber of the tube to working pressure 0.25 bar
2.3.3 The boat can be deflated and rolled up with slates inside the boat, and
can be removed for cleaning or replacing
2.4 Assembly for DS-230/265
bar
D S - 2 3 0 / 2 6 5
bar
bar
bar
bar
2-2
2.4.1 Unfold and stretch out the inflatable floor over the bottom and keel of
the boat, edging it under the half-inflated tubes and wooden floor guard
on the transom. The valve should face upwards. The valve of the keel
should also be visual and usable through hole on the front of inflatable
floor
2.4.2 Inflate the floor up to ¾.
2.4.3 Install the wooden seat.
2.4.4 Finish inflating tube to its working pressure 0.25 bar
2.4.5 Finish inflating the floor to 0.60 bar.
2.4.6 Fully inflate the keel 0.35 bar.
2.4.7 Put oars onto the lock pins.
2.4.8 Check the working pressure on every valve with a pressure gauge and
close valve caps.
2.5 Assembly for DS-290/320/360/390/420
NOTE : a. Identifying numbers on floor boards must face upwards.
b. Valve of keel should be visual and usable through hole on