Sven MS-2070 - Preparation and Operation

ENG
Operation Manual
MS-2070
5
l TUN +/-: manual band scanning (in the Radio mode)
m VOL+/-: volume level control
n
, : Previous/Next track (in the Player and Bluetooth
mode); previous/next station (in the Tuner mode);
ON/OFF backlight (pressed long)
o
, AUTO: Play/Pause (in the Player and Bluetooth mode);
start/stop auto scan (pressed long in the Tuner mode)
p 0-9: numeric pad (select track number in the Player mode or
track number FM Radio)
Battery Installation
• Open the battery compartment on the back of the remote
control.
• Insert the included AAA batteries.
• Close the battery compartment.
Notes:
• Use the RC at an angle no more than 30° at a distance of
no more than 7 meters.
• Direct the remote control at the LED display on the
subwoofer.
• If the remote control does not work, check the batteries
or replace the discharged batteries with new ones.
• Remove the batteries from the RC if you don’t intend to
use it for a long time.
5. PREPARATION AND OPERATION
Speaker placement
• Place the speakers symmetrically to the listener at least
one meter away. The subwoofer emits non-directional sound,
therefore it can be located in any place of the room where it
sounds the best.
• Place MSS far away from monitors and TV sets, as insignicant
image distortion in these supersensitive devices is possible.
Installation and operation
Fig. 4. Remote
control
MS-2070 speaker system can be connected to virtually any audio devices: МР3 player, PCs, laptops,
etc. (see connection diagram in Fig. 5).
• Before making any connections, make sure the MSS is o and unplugged. Connect the right
speaker to the subwoofer AUDIO OUTPUT R with the built-in audio cable and the left speaker – to
the AUDIO OUTPUT L.
• To use satellites backlight, connect the built-in cable of each satellite to the connectors LED1/
LED2 h.
• To connect the MSS to a PC, МР3 player, use a 2RCA to mini-jack signal cable (included). Insert
the RCA jacks of the signal cable into the L and R jacks of the PC AUDIO INPUT j, and the mini-jack
of the signal cable – into the LINE OUT port of your PC sound card or an audio output of your МР3
player, as shown in Fig. 5.