Sven MS-2250 - Page 8

ENG
8
2.1 Multimedia
Speaker System
* You might have to enter “0000” code to connect some models of devices via Bluetooth.
** If an item has been already registered in the device list of a source, then the second search
mode activation is not obligatory. Choose only the item name and the “connect” command
onthe source.
Tuner Mode
• To switch to the Tuner mode, use the INPUT b button on the front panel or INPUT button a
on the remote control.
• To auto scan and memorize the found stations, press button e on the front panel or theAUTO
n button on the remote control short. To stop auto scanning, press this button again before
the scanning is over. The display a will show the frequency being scanned. When the channel
is being memorized, the display shows its number for a short moment.
• For manual scanning, use buttons TUNE-/+ c on the remote control (up/down the frequency
range). To save the selected station, press the SAVE r button on the remote control and then,
using buttons c and f on the front panel or buttons d and m on the remote control, assign
the station its number and press the SAVE button again. When the station has been memorized,
the display a will write “Good”.
• If preset stations are available in the memory, you can switch from one to another by short
pressing buttons c, f on the front panel or buttons d, m on the remote control. You can also
enter the frequency or the number of the preset station with the remote control numeric pad
buttons g. The display will show the station number for a short moment and then its frequen-
cy. The radio will tune to the set frequency within 2-3 seconds.
AUX/PC Mode
• To switch to the AUX/PC mode, press the INPUT b button on the front panel or button INPUT
a on the remote control, the MSS switched on. The display a will show AUX or PC.
Clock Mode
• When the MSS is in the ST-BY mode, the display a shows the current time. When the system
isin a dierent mode, to see the time, use the CLOCK j button on the remote control. Thecur-
rent time will show for 3-5 seconds.
• To set the current time, go to the ST-BY mode by pressing button e on the front panel orbutton q
on the remote control long. To enter the time setting mode, press the SET l button onthe remote
control (the corresponding position will start blinking on the display a). Set theminutes and hours
directly from the RC numeric pad or using buttons c, f on the front panel or d, m on the RC.
Toswitch between setting hours/minutes and to exit the setting mode, press the RC SET l button short.
ST-BY Mode
• To enter/exit this mode, press and hold down button e on the front panel or button q ontheRC.
When the MSS is in the ST-BY mode, the display a shows the current time.
SLEEP Mode
• The SLEEP mode enables to switch over the device in the ST-BY mode after a lapse of time
chosen by a user. Press button p on the remote control to enter the SLEEP mode. To leave
theSLEEP mode, press button p on the remote control once again, while there is “0” character
on the display.
MUTE Mode
• To enter the MUTE mode, press button o on the remote control. To exit the MUTE mode,
press this button again.