Sven MS-2250 - Troubleshooting; Technical Specifications

ENG
9
MS-2250
User Manual
Note. Due to the constant development of the software, the actual MSS operation may dier from
that described in this manual. The most recent version of the manual is available atwww.sven..
7. TROUBLESHOOTING
Problem Cause Solution
The MSS
doesnotturn on.
The MSS isn’t connected
toamains outlet.
Check the connection.
The power switch is off. Turn on the switch.
No sound
orthesound
is too quiet.
Volume level is set at
minimum value.
Adjust the volume control knob.
Improperly connected audio
source.
Connect the audio sources correctly.
Distortion
ofsound.
Large amplitude of the input
signal.
Turn down the source volume
andtheMSS volume.
The remote control
is not working.
The batteries are discharged Replace the batteries with new ones.
If none of the above methods can solve the problem, please seek professional advice at your
nearest service center. Never attempt to repair the product yourself.
8. TECHNICAL SPECIFICATIONS
Parameter, measurement unit Value
Output power (RMS), W:
subwoofer
satellites
80 (50 + 2 × 15)
50
2 × 15
Frequency response, Hz:
subwoofer
satellites
40–200
200–20 000
Speaker diameter, mm:
subwoofer
satellites
Ø 140
Ø 37 + Ø 80
Power supply, V/Hz
~230/50 ⧈
Rated current consumption, A 0.1
Dimensions, mm:
subwoofer
satellites (one speаker)
198 × 345 × 305
120 × 216 × 103
Weight, kg
7.7
Notes. Technical specications given in this table are supplemental information and cannotgive
occasion to claims. Technical specications and package contents are subject tochange without
notice due to the improvement of SVEN production.