Sven PS-360 - Connection and Operation; Battery Charging; Bluetooth Mode Operation

ENG
4
Portable Speaker System
withBluetooth and FM-radio
i MIC: connector for microphone
j USB: USB-ash connector.
k AUX: 3.5 mm mini-jack for audio signal connecting (phone, MP3 player, etc.).
l DC 5V: Type-C jack for connecting speakers to the charger, the USB port of laptop/PC.
m RESET: reset button
CONNECTION AND OPERATION
Attention! The built-in battery must be charged completely prior to the application.
Speaker system battery charging
• Connect speaker system to a USB port of PC or USB charger using USB to USB type-C cable
(included). When charging, theindicator h shows battery charging progress.
• The battery is used in the speaker system as an integral part ofthe device, therefore do not try
to extract or replace it, because this can result in the warranty cancellation or the device damage.
OPERATION MODES
Bluetooth mode
• Wireless data transfer via the Bluetooth protocol enables to connect speaker system to compat-
ible devises. Maximum radius of action of data transfer is 10 m. Such obstacles as walls orother
electronic devices can interfere with the signal transfer.
• Turn on the speakers in Bluetooth mode.
• It is necessary to select the search mode of devices with Bluetooth on a signal source (tele-
phone, notebook, smartphone, etc.). “SVEN PS-360” message will be displayed on the screen
which is to be connected to*.
• When connection is successful, there will be a short beep**.
Fig. 2.