Sven PS-740 - Operation Modes

ENG
5
PS-740
User Manual
OPERATION MODES
Bluetooth mode
• Wireless data transfer via the Bluetooth protocol enables to connect speaker system to com-
patible devises. Maximum radius of action of data transfer is 10 m. Such obstacles as walls oroth-
er electronic devices can interfere with the signal transfer.
• Turn on the speaker system Bluetooth mode — press button МODE l several times until
display shows “bt” inscription.
• It is necessary to select the search mode of devices with Bluetooth on a signal source (tele-
phone, notebook, smartphone, etc.). “SVEN PS-740”, massage will be displayed on the screen
whichis to be connected to*.
• When connection is successful, there will be a short beep and the indication of the search
mode on speaker system is over**.
* You might have to enter “0000” code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second search
mode activation is not obligatory. Choose the item name “SVEN PS-740” andthe “connect”
command on the source.
Connecting to the speaker via Bluetooth using NFC
NFС works only with Android devices (version 4.1 and later).
To connect the speaker to a smartphone, the smartphone must be equipped with an NFC chip.
It must be enabled in the wireless settings.
• Turn on the speaker system Bluetooth mode — press button МODE l several times until
display shows “bt” inscription.
• Hold the phone close to the NFC mark o on the top panel and wait for a short beep to conrm
a successful speaker connection.
Note. You need to allow connections on the phone (depending on the phone’s operating system).
Radio mode
Attention! To improve the reception quality of the radio signal, connect the 3.5 mm mini-jack
cable (included) to the AUX input
e.
Fig.3. Connection diagram
Mini-jack to mini-jack
signal cable
Socket
USB power
adapter
PC
Mobile
device
USB to USB type-C
power cable