What to do if there is no sound from my Sven PS-50?
If there's no sound or the Sven Speaker System's volume is too low, first, try pressing the «vol+» button on the front panel to increase the volume. Also, make sure the audio source is correctly connected and selected.
Why is the sound distorted on my Sven Speaker System?
If you are experiencing sound distortion with your Sven Speaker System, it might be due to a large amplitude of the input signal. Try turning down the volume on both the source and the Speaker System itself.
How to fix a Sven PS-50 that does not turn on?
If your Sven Speaker System doesn't turn on, the battery may be discharged. To resolve this, connect the Speaker System to a charger or the USB port of a notebook or PC to charge the battery.
Details components and controls of the PS-50 multimedia speaker system, including buttons, display, and ports.
Instructions on where to place the device for optimal use and to avoid potential image distortion on sensitive devices.
Guide on connecting the speaker system to various audio devices like PCs, notebooks, and MP3 players using cables and ports.
How to use the player mode with USB flash or micro SD cards, including source selection and track navigation.
Instructions for tuning into radio stations, performing automatic scans, and storing found stations.
Steps to activate and use the AUX input for external audio sources, indicated by 'AUX/LINE' on the display.
How to turn the speaker system on and off by pressing and holding the designated button.
General| Total Harmonic Distortion | < 1% |
|---|---|
| Supported Bluetooth Profiles | A2DP, AVRCP |
| FM Radio | Yes |
| Input Sensitivity | 500 mV |
| Impedance | 4 Ohm |
| Connectivity | Bluetooth, USB, AUX |
| Signal-to-Noise Ratio | 75 dB |
| Power Supply | DC 5V |
| Playback from Flash Memory | Yes |
To Next Page
