What to do if my Sven Speaker System has no sound?
If your Sven Speaker System has no sound, first, try increasing the volume level. If that doesn't work, check the connection of the audio source to ensure it is properly connected.
How to fix a Sven SPS-702 Speaker System that does not turn on?
If your Sven Speaker System (MSS) does not turn on, make sure it is properly plugged into the mains outlet. Also, check that the power switch is turned on.
What to do if there is no sound from my Sven SPS-702 Speaker System?
If you're not getting any sound from your Sven Speaker System, there are a couple of things to check: * First, make sure the volume isn't set too low; adjust the volume control knob. * Second, ensure your audio source is properly connected.
Why my Sven Speaker System does not turn on?
If your Sven Speaker System isn't turning on, here's what you should check: * First, verify that the speaker is properly connected to a mains outlet. * Second, make sure the power switch is turned on.
How to fix sound distortion in Sven Speaker System?
If you're experiencing sound distortion with your Sven Speaker System, the input signal may be too strong. Try turning down the volume on both your audio source and the speaker system itself.
What to do if Sven SPS-702 Speaker System sound is too quiet?
If the sound from your Sven Speaker System is too quiet, try adjusting the volume control knob. It might be set at the minimum value.
Lists key features including built-in transformer, controls, compatibility, headphone jack, power LED, magnetic shielding, and MDF cabinets.
Instructions on optimal speaker positioning for sound quality and avoiding interference.
Detailed steps for connecting the speaker system to various audio sources using provided cables.
General| Type | 2.1 Speaker System |
|---|---|
| Frequency Response | 40 Hz - 20 kHz |
| Signal-to-Noise Ratio | ≥ 70 dB |
| Input Sensitivity | 500 mV |
| Frequency Range | 40 Hz - 20 kHz |
| Power Supply | AC 220V, 50 Hz |
| Total Power Output | 40 W |
| Subwoofer Power | 20 Watts |
| Satellite Power | 10 Watts x 2 |
| Impedance | 4 Ohms |
| Total Harmonic Distortion | < 0.5% |
| Input Impedance | 10 kOhms |
To Next Page
