What to do if there is no sound from my Sven Speaker System?
If you're not getting any sound from your Sven Speaker System, there are a couple of things to check: * Make sure the volume isn't set too low; adjust the volume control knob. * Verify that your audio source is properly connected. If not, connect audio sources correctly.
Why my Sven SPS-607 Speaker System does not turn on?
If your Sven Speaker System isn't turning on, check these potential causes: * Ensure the speaker system is properly connected to the mains outlet. * Confirm that the power switch is in the 'on' position.
How to fix sound distortion on Sven SPS-607 Speaker System?
If you're experiencing sound distortion with your Sven Speaker System, it could be due to a large amplitude of the input signal. Try turning down the volume on both your audio source and the speaker system itself.
What to do if the sound of my Sven SPS-607 Speaker System is too quiet?
If the sound from your Sven Speaker System is too quiet, the volume level might be set too low. Try adjusting the volume control knob to increase the sound level.
High voltage warning; do not open or touch internal elements to avoid electric shock.
Recommendations for optimal speaker positioning relative to the listener and surrounding environment.
Steps and diagrams for connecting the speaker system to various audio sources.
General| Total Power Output | 10 W |
|---|---|
| Impedance | 4 Ohm |
| Input Sensitivity | 500 mV |
| Connectivity | 3.5mm jack |
| Power Supply | 5V via USB |
| Material | Plastic |
| Signal/Noise Ratio | ≥70dB |
To Next Page
