What to do if there is no sound from my Sven Speaker System?
If there is no sound from your Sven Speaker System, first, check whether the volume level is set at the minimum. If it is, adjust the volume control knob. Also, ensure that the audio source is connected correctly. If not, please connect the audio sources properly.
Why my Sven Speaker System does not turn on?
If your Sven Speaker System does not turn on, check if it is properly connected to a mains outlet. If not, connect it. Also, verify that the power switch is turned on. If it is off, turn it on.
How to fix sound distortion on Sven Speaker System?
If you are experiencing sound distortion with your Sven Speaker System, it might be due to a large amplitude of the input signal. To resolve this, turn down both the source volume and the MSS volume.
What to do if Sven Speaker System volume is too low?
If the sound from your Sven Speaker System is too quiet, the volume level might be set at the minimum. Try adjusting the volume control knob to increase the sound level.
Why is there no sound from my Sven Speakers?
If you are experiencing a lack of sound from your Sven Speakers, there could be a couple of reasons. First, ensure that the volume isn't set too low; try adjusting the volume control knob. Secondly, check that the audio source is properly connected.
What to do if my Sven Speakers have distortion of sound?
If you notice sound distortion in your Sven Speakers, it might be due to a large amplitude of the input signal. Try turning down the volume on both the source and the MSS (Multimedia Speaker System).
How to fix too quiet sound of Sven Speakers?
If the sound from your Sven Speakers is too quiet, the volume level may be set at minimum. Adjust the volume control knob to increase the sound.
How to troubleshoot Sven Speakers that do not turn on?
If your Sven Speakers aren't turning on, there are a couple of things to check: 1. Make sure the speakers are properly connected to a mains outlet. 2. Verify that the power switch is in the 'on' position.
General| Type | 2.1 Speaker System |
|---|---|
| Total Power Output | 38 W |
| Frequency Response | 40 Hz - 20 kHz |
| Material | Wood (subwoofer), plastic (satellites) |
| Input Impedance | 10 kΩ |
| Signal/Noise Ratio | ≥ 75 dB |
| Power Supply | 220V, 50Hz |
To Next Page
