Why is there sound distortion in my Sven SPS-820?
If you are experiencing sound distortion with your Sven Speaker System, it might be due to a large amplitude of the input signal. Try turning down the source volume and the MSS volume to resolve this.
What to do if my Sven SPS-820 has no sound?
If your Sven Speaker System has no sound, first ensure that the volume level isn't set to the minimum. If it is, adjust the volume control knob. Also, check that the audio source is correctly connected.
Why is sound produced by only one channel on my Sven SPS-820 Speaker System?
If sound is only coming from one channel of your Sven Speaker System, the speakers might be improperly connected to the audio source. Check the speaker connections to ensure they are properly connected.
How to fix a Sven Speaker System that does not turn on?
If your Sven Speaker System does not turn on, first check if it is properly connected to the mains outlet. If not, check the connection. Also, make sure the power switch is turned on.
What to do if the sound of Sven SPS-820 Speaker System is too quiet?
If the sound from your Sven Speaker System is too quiet, make sure the volume level isn't set to the minimum. Adjust the volume control knob to increase the sound level.
What to do if there is no sound from my Sven Speaker System?
If you are experiencing a lack of sound from your Sven Speaker System, there are several potential causes. Ensure the power plug is fully inserted and that the output and input cables are correctly connected. Also, verify that the volume control is not set to the minimum; adjust it as needed. The input format may also be incorrect.
Why do my Sven Speakers sound distorted?
If your Sven Speakers are producing distorted sound, it's likely due to a large amplitude of the input signal. To resolve this, turn down the volume on both the source and the MSS (speaker system).
What to do if there is no sound from my Sven Speakers?
If you're not getting any sound from your Sven Speakers, make sure the volume isn't set to the minimum. Adjust the volume control knob to increase the sound level. Also, verify that the audio source is correctly connected.
Why is sound only coming from one Sven Speakers channel?
If sound is only coming from one channel of your Sven Speakers, the speakers might not be properly connected to the audio source. Check the speaker connections to ensure they are correctly set up.
How to fix Sven Speakers that won't turn on?
If your Sven Speakers are not turning on, first, check if the MSS (speaker system) is properly connected to the mains outlet. If it is, ensure that the power switch is turned on.
Guidance on optimal positioning of speakers and subwoofer for best sound quality and minimal interference.
Instructions for connecting the speaker system to audio sources and initial setup procedures.
General| Signal/Noise ratio | ≥ 75 dB |
|---|---|
| Input Impedance | 10 kΩ |
| Type | 2.1 |
| Subwoofer Power Output | 20 W |
| Frequency Response | 40Hz - 20kHz |
| Power supply | ~220 V, 50 Hz |
| Material | Wood (subwoofer) |
| Dimensions (Satellite/Speaker) | 90 x 150 x 100 mm |
To Next Page
