What to do if there is no sound from my Sven Speaker System?
If there is no sound from your Sven Speaker System, first, check whether the volume level is set at the minimum. If it is, adjust the volume control knob. Also, ensure that the audio source is connected correctly. If not, please connect the audio sources properly.
Why my Sven SPS-614 Speaker System does not turn on?
If your Sven Speaker System does not turn on, check if it is properly connected to a mains outlet. If not, connect it. Also, verify that the power switch is turned on. If it is off, turn it on.
How to fix sound distortion on Sven SPS-614?
If you are experiencing sound distortion with your Sven Speaker System, it might be due to a large amplitude of the input signal. To resolve this, turn down both the source volume and the MSS volume.
What to do if Sven SPS-614 volume is too low?
If the sound from your Sven Speaker System is too quiet, the volume level might be set at the minimum. Try adjusting the volume control knob to increase the sound level.
General| Type | 2.1 Speaker System |
|---|---|
| Total Power Output | 40 W |
| Subwoofer Power | 20 W |
| Frequency Response | 40 Hz - 20 kHz |
| Signal-to-Noise Ratio | ≥ 75 dB |
| Satellite Power | 2 x 10 W |
| Impedance | 4 Ohms |
| Total Harmonic Distortion | <0.3% |
| Power Supply | 220 V, 50 Hz |
| Material | Wooden enclosure (Subwoofer), Plastic (Satellites) |
To Next Page
