ENG
9
PS-950
User Manual
* You might have to enter “0000” code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second search
mode activation is not obligatory. Choose the item name “SVEN PS-950” and the “connect”
command on the source.
Radio mode
Attention! To improve the quality of radio signal reception, connect the 3.5 mm mini-jack ca-
ble (included) to the LINE IN input c.
• Turn on the speaker system — press button MODE j on spekaer or b on Remote control
several times until the display shows the station frequency.
Player mode
Attention! The le system of a USB ash carrier is FAT32. Maximum volume is 32 GB.
Turn on the speaker system in USB/microSD card mode — press button MODE j on spekaer
or b on Remote control several times until the display
shows "USB"/"card".
The use in the wired mode (LINE IN)
• Speaker system can be used as an external device for amplifying any audio source. Connect
a 3.5 mini-jack to the audio input LINE IN c. Turn thespeakers to the LINE IN mode — press
the MODE j on spekaer or b on Remote control several times until “LINE” appears on the
display.
Connecting an additional speaker
For model PS-950 you can connect an additional speaker.
• On the slave speaker press button TWS n on control panel.
• The slave spekaer will display "SLAU"
• Connect the signal source via Bluetooth. Both speakers will appear in the search list as one
device.
TECHNICAL SPECIFICATIONS
Parameter, measurement unit Value
Frequency response, Hz 35–20 000
Output power (RMS), W 160 (2 × 80)
Speaker diameter 2.5" (58 mm) + 5.5" (140 mm)
Power supply ~230 V / 50 Hz
Battery 7.4 V, 8 800 mA·h (65.12 W·h)
Weight, kg
9.2
Dimensions, mm 265 × 265 × 1018
Notes. Technical specications given in this table are supplemental information andcan-
not give occasion to claims. Technical specications and package contents are subject
tochange without notice due to the improvement of SVEN production.
Technical support is on www.sven..