Need help?Do you have a question about the SVS PB13-Ultra and is the answer not in the manual?
Place the subwoofer on the same wall as the front speakers for optimal performance.
Connect LFE output, set input level to Normal, power mode to Auto, and connect power cord.
Set the main power switch to ON (I) after connecting the power cord.
Press and hold Feature Control knob to illuminate display and access menus.
Follow A/V receiver auto-set-up; adjust volume for calibration.
Connect pre-amp L/R outputs to subwoofer, and subwoofer L/R outputs to amplifier.
Use Merlin tool for Low Pass filter settings and adjust Gain Volume for level matching.
Read instructions, heed warnings, keep instructions, follow all guidance, and use only specified accessories.
Do not use near water, block ventilation, install near heat sources, or expose to rain/moisture.
Protect power cord, use proper outlets, unplug during storms, and refer servicing to qualified personnel.
Use specified carts/stands, exercise caution with moving carts to avoid tip-over, and do not defeat safety plugs.
To Next Page
General
