SWAGTRON EB5 Pro Plus - Disposal at End-of-Life

16
ENGLISH SWAGTRON EB5 Pro Plus Electric Bike
• Never use the eBike to do anything that may cause personal injury or property damage.
• Never get off the eBike when it is in motion.
FAILURE TO USE COMMON SENSE AND HEED THE ABOVE WARNINGS INCREASES THE RISK OF SERIOUS
INJURY OR, IN VERY RARE CASES, DEATH. USE WITH APPROPRIATE CAUTION AND SERIOUS ATTENTION
TO SAFE OPERATION.
For more safe riding tips or information, visit www.swagtron.com.
6.1 Disposal at End-of-Life
This product must not be disposed of by incineration, landlling, or mixing with household trash. Improper disposal
of the battery contained within this product may result in the battery heating up, rupturing, or igniting which may
cause serious injury. The substances contained inside the battery present chemical risks to the environment. The
recommended disposal for any SWAGTRON
®
product at its end-of-life is to dispose of the entire unit at or through
an e-waste recycling center, program, or facility. Local regulations and laws pertaining to the recycling and disposal
of lithium-ion batteries and/or products containing them will vary according to country, state, and local governments.
You must check laws and regulations corresponding to where you live in order to properly dispose of the battery
and/or unit. It is the user’s responsibility to dispose of their waste equipment properly with accordance with local
regulations and laws.
For additional information about where you should drop off your batteries and electrical or electronic waste, please
contact your local or regional waste-management ofce, your household waste disposal service, or your point-of-
sale.
Section 7. Maintenance
• Do not perform any kind of maintenance while the eBike is charging.
• Attempting to repair or modify your eBike can void all warranties. Only authorized repair centers may
open and service the eBike.
If you need assistance, please contact SWAGTRON
®
support at support@swagtron.com.
7.1 Tire Ination
You will need a pressure gauge, a standard bicycle pump to inate the EB5 Pro Plus eBike’s tires.
Step 1. Ensure the eBike is powered off and stable, so it doesn’t move during ination.
Step 2. Visually inspect the tires for damage, scuff, or puncture marks. If the tire is damaged, DO NOT INFLATE IT.
Contact customer service immediately.
Step 3. Find the valve located on the inside of the wheel and remove the cap.
Step 4. Use a standard bicycle pump to pump air to the tires slowly.
Step 5. Use the pressure gauge periodically to check PSI.
Step 6. When the tire reaches 35-45 PSI/2.4-3.1BAR, stop inating and replace the valve cap.
Step 7. Repeat with other tire.