SWAGTRON EB5 Pro Plus - Section 7. Maintenance; Tire Inflation

17
ENGLISHSWAGTRON EB5 Pro Plus Electric Bike
Section 7. Maintenance
• Do not perform any kind of maintenance while the eBike is charging.
• AttemptingtorepairormodifyyoureBikecanvoidallwarranties.Onlyauthorizedrepaircentersmay
open and service the eBike.
If you need assistance, please contact SWAGTRON
®
support at support@swagtron.com.
7.1 Tire Ination
You will need a pressure gauge, a standard bicycle pump to inate the EB5 Pro Plus eBike’s tires.
Step 1. Ensure the eBike is powered off and stable, so it doesn’t move during ination.
Step 2. Visually inspect the tires for damage, scuff, or puncture marks. If the tire is damaged, DO NOT INFLATE IT.
Contact customer service immediately.
Step 3. Find the valve located on the inside of the wheel and remove the cap.
Step 4. Use a standard bicycle pump to pump air to the tires slowly.
Step 5. Use the pressure gauge periodically to check PSI.
Step 6. When the tire reaches 35-45 PSI/2.4-3.1BAR, stop inating and replace the valve cap.
Step 7. Repeat with other tire.