7
Notes
Troubleshooting
Q: On my Swann DVR, ‘Video Loss’ appears where the image from my camera should
be.
A: Check the extension cable (power and video) is securely connected to the camera.
Check the video output from the camera is securely connected to a video input
channel on the DVR. Check the power from the camera is securely connected to a
power supply.
Q: When I view an image from the camera at night I only see a bright spot and no
image.
A: A reection can be caused in night vision mode if the camera is looking through
a window. Move the camera to the other side of the window or to another location.
Q: The BNC extension cable will not connect to my TV.
A: Many TV’s and monitors do not have a BNC connector but do have an RCA
connector. Connect a BNC to RCA adapter to the end of the extension cable and then
plug into the RCA socket on your TV or monitor.
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
______________________________________________________________
To Next Page
Loading...
