Need help?Do you have a question about the Swegon GOLD RX 80 and is the answer not in the manual?
Advises on instructions, risks of improper handling, and rotating parts.
Lists the step-by-step procedure for commissioning the unit.
Describes terminal components, display, and button functions.
Regulation based on a factory-preset curve with breakpoints.
Regulation using a custom curve with adjustable breakpoints.
Protects the rotary heat exchanger from frosting by monitoring pressure drop.
Configuration of fire alarm inputs and fan operation during fire events.
Step-by-step guide for filter replacement and cleaning.
How alarms are displayed and faults are traced.
Details alarms related to fire protection and frost monitoring.
Alarms for faulty sensors and communication failures.
Alarms related to frequency converters and voltage issues.
Alarms for over/under temperature and current in converters.
Alarms for pressure deviations and airflow setpoints.
Alarms for airflow above or below setpoints.
Alarms indicating clogged filters.
Alarms for expired service periods and communication loss.
Alarms for CoolDX unit operation and temperature monitoring.
Alarms for CoolDX sensors and compressor restarts.
Alarms for ReCO₂ communication and preheating issues.
Alarms for COOL DXS component trips and phase sequence errors.
Alarms related to water temperature sensors and control.
Alarms for fan motor blockages and voltage fluctuations.
Communication alarms for CONTROL Optimize and I/O modules.
Alarms for COOL DXS component trips and excessive restarts.
Alarms for COOL DXS fan trips and phase sequence errors.
Details alarms for fire, frost, sensors, communication, and converters.
Alarms related to voltage, temperature, and heat exchangers.
Alarms for pressure, airflow, filters, and service periods.
Alarms for COOL DXS unit operation, fans, and restarts.
Alarms for extra zones and COOL DXS pressure.
To Next Page
General
