Services
27
MICROSWITCH TAPS
The micro switch taps are used when the
water supply is not pressurised.
When the tap is turned on the micro switch
(which is fitted inside the tap) activates the
pump to supply water.
Operation
Swivel the tap spout (a) to the desired
position over the sink, lift the control lever (b)
to activate the pump and allow water to flow
simultaneously. To adjust the temperature
swivel the lever (c) to the left or right as
shown opposite.
Note: Before commencing microswitch
replacement ensure instructions are read
through thoroughly. The entire process can
be completed without the need to remove
the tap from the worktop.
Step 3
- Remove the dome
- Remove the small screw
between cartridge and
closure
Step 4
- Remove the snap ring
(small plastic piece)
Step 5
- Remove the snap ring
with the Pipe wrench
(Turn left or right)
Step 6
- Pull the cartridge out of
the housing
- Remove the old
microswitch
Before you Start
1. Ensure pump is isolated.
2. Position lever in central, i.e. mixer, off
location.
COMET ROMA SINGLE LEVER MIXER TAP
Required tools
- Pipe wrench
- Cross-point
screw-driver
- Flat-bladed
screw driver
inside the
handle.
Step 1
- Remove the
marker cap
Step 2
- Remove the
screw from
the control
knob
- Pull the
microswitch
out of the
control knob
Tools
1
43
5
6
2
To Next Page
Loading...
Need help?
General
