Swift 2004 User Manual

- open the windows and leave the room;
- contact the Customer Service
department of Thetford.
• You suspect a leak in the cooling system:
- switch off the refrigerator;
- extinguish any naked flames;
- provide sufficient ventilation;
- contact the Customer Service
department of Thetford.
ABOUT YOUR REFRIGERATOR
Your refrigerator has a cold space and a
freezer compartment. After starting up the
refrigerator, allow it to cool for at least eight
hours before placing any food in it.
Cold space
The condenser is located on the inside of
your refrigerator. The absorber system uses
the condenser to draw off heat from the
refrigerator. Therefore, never place plastic or
paper over the condenser. Air must be able
to circulate freely through the refrigerator so
that heat can be extracted.
Important! Do not cover the condenser at
the back of the refrigerator with plastic or
paper. The refrigerator cools optimally when
air is allowed to move freely through the
refrigerator.
• To limit frosting on the condenser:
- always cover liquid foods before placing
them in the refrigerator;
- always let hot food cool before placing
it in the refrigerator;
- never keep the refrigerator open longer
than necessary.
Fitting racks
Inside your refrigerator there are two or three
storage racks. You can adjust the racks to a
convenient height by means of a simple click
system:
• click the plastic bracket to the right short
side of the rack;
• turn the bracket into the horizontal
position and insert the rack tipped in a
sloping position into the refrigerator;
• place the short side without bracket into
one of the grooves on the left wall of the
refrigerator;
• place the short side with bracket in the
corresponding groove on the right wall of
the refrigerator;
• turn the bracket downwards to fix it into
the groove.
To move a rack, turn the bracket upwards
and remove the rack. Place the rack at the
required height in the way described above.
Securing products for driving
One of the racks in your refrigerator has a
system for securing products for driving. The
system consists of a simple click-and-slide
plastic strip. To secure products on the rack
while driving, push the plastic strip as tightly
as you can against the products on the rack.
In the storage space on the inside of the
refrigerator door, there is the unique Thetford
flexible bottle slide. The slide prevents bottles
from sliding around during driving. Push the
slide against the products in the door or
place the products between the bottle slide.
Fitted Equipment
82

Swift 2004 Specifications

General

Brand	Swift
Model	2004
Category	Motorhomes
Language	English