33
1.
Brompton Specific
Torque Washer
1.1
1.3
1.2
To fit the Brompton torque washer,
first thread the motor cable through
the keyhole in the washer. Angle the
washer with the lip facing towards
the forks.
Slot the torque washer into the
Brompton forks.
Remove any of the existing wheel
hardware.
1.4
Tighten and secure the nut, being
careful not to pinch the motor cable.
Note
If you have a mudguard, assemble it
underneath the locking nut.
!
Ensure the torque washer is
fitted correctly.
To Next Page
Loading...
