Using Your Kit
41
2.
1.1
1.3
1.2
Lift up the mount handle so that it’s
fully open.
Push down the mount handle until
it’s fully engaged.
Fit the bottom of the Power Pack
into the mount alignment block.
Then tilt the Power Pack to line up
the two yellow connectors.
Starting Your Ride
1.1
1.2
1.3
Note
In the rare case that your mount
handle becomes significantly looser
over time, contact our team for
advice on how to adjust it.
1. Connect the Power Pack
!
Avoid trapping anything in the
mount mechanism.
Check the connector area is
completely dry before
connecting to the mount.
!
To Next Page
Loading...
