11. List of the main commands
Selection and conguration Interrogation
CHA+ / CHA- Change measurement direction CHA? Measurement sense?
FCT0 ...9...A...F Assign «favourite» function FCT? «favourite» function active?
MM / IN Change measurement unit UNI? Measurement unit active?
KEY0 / KEY1 Lock / unlock keypad KEY? Keypad locked?
MUL [+/-]xxx.xxxx Modify multiplication factor MUL? Multiplication factor?
PRE [+/-]xxx.xxx Modify preset value PRE? Preset value?
REF1 / REF2 Change active reference REF? Reference active?
STO1 / STO0 Activate / de-activate HOLD STO? Status of HOLD function?
TOL1 / TOL0 Activate / de-activate tolerances TOL? Current tolerance limit values?
LCAL dd.mm.yy Modify last calibration date LCAL? Date of last calibration?
NCAL dd.mm.yy Modify next calibration date NCAL? Date of next calibration?
TOL +/-xxx.xxx +/-yyy.yyy Inputting nominal and current tolerance limits ? Current value (mode Tol, value followed by <=>)
+/-zzz.zzz
MIN /MAX /DEL /NOR Selecting MIN, MAX, Delta, Normal mode MOD? Active mode (MIN, MAX, Delta or Normal)?
CLE Re-initialisation of MIN, MAX or Delta SET? Main instrument parameters?
UNI1 / UNI0 Activate / de-activate change of units ID? Instrument identication code?
OUT1 /OUT0 Activate / de-activate contin. data transmission Maintenance functions
PRE ON / PRE OFF Activate / de-activate Preset function BAT? Battery status (BAT1 = OK, BAT0 = low battery)
PRE Recall Preset OFF Switch-off (wake up using a button or RS)
SET Zero reset RST Re-initialisation of the instrument
RES2 / RES3 Change of resolution SBY Put instrument in stand-by (SIS)
VER? Version No. and date of rmware
To Next Page
Loading...
Need help?
General
