10
QUICKSTART
7 PACKING UP THE MACHINE
7.1 Secure the moving parts
Connect the machine to the computer. In the Sylvac-Reflex Scan+ software, select the “Service” tab, then “Plugins” and
the “Parkem Controller” diagnostics button (Figure 9).
Figure 9
7.2 Affix the safety components
Figure 10.
Figure 10
The machine will move into the correct position (approx. 390 mm). When it is in the correct position, a warning message
will tell you to fit the correct accessory to hold the tailstock in place. Press OK.
To Next Page
Loading...
