9
QUICKSTART
8 - Press the Compose button to create or edit a programme:
You will then be able to enter the nominal values to compare with the measured values or add new parameters by selecting
them from the tool box (blue: static parameters, red: dynamic parameters) and move your mouse over the contours of the
piece to define the area of interest.
9 - Once you have entered the changes, press the Reflex-Click button. You will be asked to save your programme before
running it.
6. MAINTENANCE AND SERVICING
The maintenance and servicing of the machines must be performed by people trained and qualified by Sylvac SA or its
official agents.
During servicing or maintenance, switch off the machine completely using the main ON/OFF switch (I). Otherwise, activate
the “Service mode” button on the main panel in order to deactivate the safety light curtain.
Important note : do not forget to deactivate the “service mode” button when the maintenance or servi-
cing work has been completed.
To Next Page
Loading...
Need help?
General
