8
QUICKSTART
5. QUICKSTART OF THE SYLVAC-REFLEX SCAN
+
SOFTWARE
1 - Turn on the machine using the ON/OFF button
2 - Start up the computer
3 - Launch the Sylvac-Reflex Scan+ software by clicking on the icon
4 - The below window will be displayed on your screen. Log in as a supervisor using the password “123”.
5 - Press the Reflex-Click button (H) on the front of the machine. Your system must be calibrated before making the first
measurement, you will receive a message to confirm the calibration request. Then press the Reflex-Click button (H) again
to continue.
6 - After completing calibration, you piece can be measured. Note that the Reflex-Click mode is selected by default.
This means that the machine will be capable of automatically detecting and executing an existing programme for the piece
to be measured or it will measure automatically the most common properties (e.g. diameter and length).
7 - Press the Reflex-Click button once more to receive the measurement results in just a few seconds!
To Next Page
Loading...
Need help?
General
