30
Rear Shock Absorber Adjustment
This scooter is equipped with 2 rear shock absorbers ○A . Each shock absorber has 4 positions for spring
preload adjustment. The standard position is 2.
Turn the adjuster ○B anti-clockwise ○a to increase preload (harder).
Turn the adjuster clockwise ○b to decrease preload (softer).
Contact your SYM dealer for adjustment.
General Lubrication
Lubricate the below parts with either engine oil or general grease in accordance with the “Periodic
Maintenance Table” or whenever the vehicle has been operated under wet or rainy conditions. Clean off
rusty spots and wipe off any oil or grease.
Side stand
Front / rear brake lever
Throttle cables
Vehicle Data Recorder
This scooter is equipped with an ECU that can record or collect vehicle data for trouble diagnosis and
research. The data must be received by a special diagnostic tool when carrying out maintenance or
check-up. SYM will not transfer the data to any third party except:
The owner or user agrees.
Stipulated by laws.
In need of lawsuit.
For research and development, and the data is irrelevant to an individual unit or the owner.
10. Taking Care of Your Scooter
Washing
Fully cool down the engine, muffler, brakes and other high-temperature parts before washing. We suggest
you to cover the muffler’s exhaust vent and shut the ignition switch slot.
Rinse your scooter with cold water from a water hose to remove dirt.
Mix a neutral detergent that is designed for scooters or automobiles and water in a bucket. Use a
sponge to wash your scooter.
After washing, rinse your scooter thoroughly with clean water to remove the residue.
Use an air gun to blow off the water and use a clean soft cloth to dry your scooter.
Carefully ride your scooter at a slow speed and apply the brakes several times to help drying the brakes.
To Next Page
Loading...
Need help?
General
