3
Verify LLT operation.
See “Verifying LLT” on page 114.
4
Verify GAB operation.
See “Verifying GAB” on page 116.
5
Verify the cluster operation.
See “Verifying the cluster” on page 117.
Verifying LLT
Use the lltstat command to verify that links are active for LLT. If LLT is
configured correctly, this command shows all the nodes in the cluster. The
command also returns information about the links for LLT for the node on which
you typed the command.
Refer to the lltstat(1M) manual page for more information.
To verify LLT
1
Log in as superuser on the node galaxy.
2
Run the lltstat command on the node galaxy to view the status of LLT.
lltstat -n
The output on galaxy resembles:
LLT node information:
Node State Links
*0 galaxy OPEN 2
1 nebula OPEN 2
Each node has two links and each node is in the OPEN state. The asterisk (*)
denotes the node on which you typed the command.
3
Log in as superuser on the node nebula.
4
Run the lltstat command on the node nebula to view the status of LLT.
lltstat -n
The output on nebula resembles:
LLT node information:
Node State Links
0 galaxy OPEN 2
*1 nebula OPEN 2
Verifying the VCS installation
Verifying LLT, GAB, and cluster operation
114
To Next Page
Loading...