Symantec Veritas Cluster Server - Configuring the Shared Storage; Bringing up the Existing Node

To install and configure Ethernet cards for private network
1
Shut down VCS on Node A.
# hastop -local
2
Shut down the node to get to the OK prompt:
# shutdown -r now
3
Install the Ethernet card on Node A.
If you want to use aggregated interface to set up private network, configure
aggregated interface.
4
Install the Ethernet card on Node B.
If you want to use aggregated interface to set up private network, configure
aggregated interface.
5
Configure the Ethernet card on both nodes.
6
Make the two Ethernet cable connections from Node A to Node B for the
private networks.
7
Restart the nodes.
Configuring the shared storage
Make the connection to shared storage from Node B. Configure VxVM on Node B
and reboot the node when you are prompted.
See “Setting up shared storage” on page 46.
Bringing up the existing node
Bring up the node.
To bring up the node
1
Restart Node A.
2
Log in as superuser.
3
Make the VCS configuration writable.
# haconf -makerw
4
Display the service groups currently configured.
# hagrp -list
145Installing VCS on a single node
Adding a node to a single-node cluster