To set up the hardware
1
Connect the VCS private Ethernet controllers.
Perform the following tasks as necessary:
■ When you add nodes to a two-node cluster, use independent switches or
hubs for the private network connections. You can only use crossover
cables for a two-node cluster, so you might have to swap out the cable for
a switch or hub.
■ If you already use independent hubs, connect the two Ethernet controllers
on the new node to the independent hubs.
Figure 7-1 illustrates a new node being added to an existing two-node cluster
using two independent hubs.
2
Connect the system to the shared storage, if required.
Preparing for a manual installation when adding a node
Before you install, log in as the superuser. You then mount the disc and put the
files in a temporary folder for installation.
123Adding and removing cluster nodes
Adding a node to a cluster
To Next Page