Symantec Veritas Cluster Server - Unloading LLT and GAB and Removing VCS on the Departing Node

To Next Page

To Previous Page

Unloading LLT and GAB and removing VCS on the departing node

Perform the tasks on the node that is departing the cluster.

If you have configured VCS as part of the Storage Foundation and High Availability

products, you may have to delete other dependent RPMs before you can delete all

of the following ones.

To stop LLT and GAB and remove VCS

If you had configured I/O fencing in enabled mode, then stop I/O fencing.

# /etc/init.d/vxfen stop

Stop GAB and LLT:

# /etc/init.d/gab stop

# /etc/init.d/llt stop

To determine the RPMs to remove, enter:

# rpm -qa | grep VRTS

To permanently remove the VCS RPMs from the system, use the rpm -e

command. Start by removing the following RPMs, which may have been

optionally installed, in the order shown:

# rpm -e VRTScmccc

# rpm -e VRTScmcs

# rpm -e VRTScssim

# rpm -e VRTScscm

# rpm -e VRTSvcsmn

# rpm -e VRTScutil

# rpm -e VRTSweb

# rpm -e VRTScscw

# rpm -e VRTSjre15

# rpm -e VRTSjre

# rpm -e VRTSvcsdr

# rpm -e VRTSvcsag

# rpm -e VRTSacclib

# rpm -e VRTSvcsmg

# rpm -e VRTSvcs

# rpm -e VRTSvxfen

# rpm -e VRTSgab

# rpm -e VRTSllt

137Adding and removing cluster nodes

Removing a node from a cluster