Scan with the Symbol CS3070
Compsulting LLC – RepTime
Rev. 09/13/2017
How to Setup the Symbol CS3070 Bluetooth Barcode Scanner
Only use this guide to setup the Symbol CS3000 Bluetooth Barcode Scanner for the first time. You will need to pair this
Bluetooth scanner to your computer, tablet, or smart phone before performing the steps below. If you do not have
your scanner paired, please follow the instruction guide that came with your device. This device is used in the order
entry of RepTime and RepTime Handheld App where you have to select catalog items. Follow the steps from 1 – 4 and
scan each barcode one after the other. Do not skip any.
You must setup the Bar Code Scanner with these instructions for it to work properly with RepTime.
Barcode Scanner Programming Instructions…
Step 1) Start Here with Scan Prefix
START HERE
Step 3) Data Transmission Format
Step 2) Prefix to Program Pipe ‘|’
Step 4) Save Configuration
STOP HERE
USE BELOW FOR TROUBLESHOOTING ONLY
Soft Reset Parameters
Factory Reset to Defaults
This information will help streamline the process. Thank you for your cooperation.
Feel free to contact RepTime if you have any questions at 214-746-3671 or support@reptime.com.
To Next Page
Need help?
General
