Symbol LS1902-T - User Manual

To Next Page

BARCODE SCANNER

Programming the LS1902-T & LS2208 for use with

StarShip

These instructions are for the Symbol LS1902-T & LS2208 Barcode scanner

ONLY!

The following instructions will allow the user to scan a bar-coded

Invoice\Order number into Starship and automatically “press” the Enter key.

Repetitive keystrokes such as SAVE, DEFER, REPEAT, and NEXT can

also be programmed. These repetitive keystrokes can be scanned using the

preprinted Barcodes at the end of these instructions.

You must tell the scanner what kind of keyboard connection you are using

by scanning the appropriate Barcode on the following page. Connect the

scanner to the PC and Keyboard while the PC is on (see page 1-6 of the

Online Manual for connection instructions). IMPORTANT: The keyboard

will be disabled until you scan one of the Barcodes on the next page.

The “ENTER” command must be programmed before any of the other

commands are entered. To program a command, “scan” each barcode in

order on that page. If you do not hear a beep or series of beeps, the scanner

did not read the barcode. Try scanning the barcode at different angles until

you hear the beep(s). If you make a mistake, scan the last barcode on that

page and start at the beginning of that page again. To reset the scanner back

to Factory Defaults scan this barcode:

Main Page

Need help?

Do you have a question about the Symbol LS1902-T and is the answer not in the manual?

Summary

Programming Barcode Scanner for StarShip

Keyboard Connection Selection

Scan the appropriate barcode to set the scanner's keyboard connection type.

ENTER Command Setup

Program the scanner to send an 'ENTER' command after scanning data.

SAVE Command Setup

Program the scanner to send a 'SAVE' command.

DEFER Command Setup

Program the scanner to send a 'DEFER' command.

NEXT Command Setup

Program the scanner to send a 'NEXT' command.

REPEAT Command Setup

Program the scanner to send a 'REPEAT' command.