Operation
12
6502B RF Distribution User Guide 15247-201 Rev. B – April 2009
ALARM
LED on the front panel to indicate that an ALARM condition exists. An alarm
condition exists when the input signal or any output signal fails or falls below the
factory preset amplitude.
INPUT FAULT
This LED is located on the rear panel between the two INPUT connectors. If the
input signal fails or falls below the factory preset amplitude, this LED will light and
stay on until the cause of the fault is remedied.
OUTPUT FAULT
There are ten LED indicators, located to the right of each output connector. If any
output signal fails or falls below the factory preset amplitude, the LED associated
with the failed output will light and stay on until the cause of the fault is remedied.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General