Symmetricom 8040C User Manual

15254-201.docx 12 Rev. C, 07/12/2011
Console
The Symmetricom Serial Interface Protocol (SSIP) provides user
communication with the 8040C/8040CLN through the serial port when the unit
is connected to a host PC or terminal. All “developer-mode” commands are
single-letter format.
Host Terminal Emulator Setup
Set up the comm port of the PC with the following configuration:
 Data rate (Baud/BPS - see note below)
 No parity
 8 data bits
 1 stop bit
 No local echo (unit echoes)
 No hardware or software flow control
All SSIP commands are a single ASCII letter. The baud rate of the
8040C/8040CLN is 57.6K.
Note: Requires a null modem cable (DTE).

Symmetricom 8040C Specifications

General

Brand	Symmetricom
Model	8040C
Category	Test Equipment
Language	English