EasyManuals Logo

Symmetricom SSU-2000e Technical Reference

Symmetricom SSU-2000e
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #201 background imageLoading...
Page #201 background image
12713140-003-2 Revision E.01 – January 2007 SSU-2000e Technical Reference 201
Chapter 3 ICS Command Reference
MTIE
MTIE
Use this command to display the MTIE (Maximum Time Interval Error) data from a
selected input port. MTIE is a measure of wander that characterizes frequency
offsets and phase transients. MTIE (tau) is the largest Peak-to-Peak TIE (Time
Interval Error) in any observation interval of length tau.
Level 0 Not applicable
Level 1
MTIE xAy-z [{A|B}] startdate [starttime][stopdate [stoptime]]
MTIE xAy-z [{A|B}] starttime [stopdate][stoptime]
MTIE xAy-z [{A|B}] HISTORY [count]
Options are:
A| B CLK A or CLK B; the default is the selected clock output.
starttime Specifies the start time of a specific period of time to be
displayed.
stopdate Specifies the date ending a specific period of time to be
displayed.
stoptime Specifies the stop time of a specific period of time to be
displayed.
If the starttime, stopdate, and stoptime are not specified,
the system defaults to a 24 hour period.
HISTORY [count]
Displays the one-day MTIE history for the last number of
days specified in the count parameter.
This command displays the MTIE information calculated on the input
module with a specified clock. A start time and stop time are required to
perform an MTIE calculation. If these are not specified in the command
line, the
starttime defaults to the last 24 hours, the stoptime defaults to
the current time.
Note: If you specify times and dates, the MTIE that occurred after the
starting date and time and before the ending date and time displays.
Specified dates have the format yyyy-mm-dd, and specified times
have the format hh:mm:ss. Specified dates and times are not
provided in ISO timestamp format, and must be separated by a
space. Starttime and stoptime both default to the current time of day.
Stopdate defaults to the current date. Startdate defaults to the current
date, minus 24 hours.

Table of Contents

Other manuals for Symmetricom SSU-2000e

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom SSU-2000e and is the answer not in the manual?

Symmetricom SSU-2000e Specifications

General IconGeneral
BrandSymmetricom
ModelSSU-2000e
CategoryPower Supply
LanguageEnglish

Related product manuals