8www.syncoaudio.com
9. Boost Mode
When poor signal, switch the Boost Mode to amplify the signal, improving communication
clarity and stability, and reducing interruptions and disconnections.
Long press the volume-, release after the 1st "Beep" sound to switch the mode and hear
“Mode 1/Mode 2/Mode 3”.
*The operation is only available by Master.
* Mode 2 by default.
*After changing the Mode, if Level 1 is restarted, please pair it with the upper-level headset
again to rejoin the communication group.
Beep
Boost
Mode 2
Release
Boost Mode 1 Boost Mode 2
10. Real-Time Monitoring
Connect the device(Camera, Camcorder, etc.) with the Xtalk headset via 3.5mm TRS port for
monitoring the audio from the device.
*This port is only for monitoring and is not the outputting port.
11. Powering
Via Replaceable Battery Power
Push down the toggle of the battery case then pull
the case door outward to place/remove the battery.
To Next Page
Loading...