12
Chapter 2: Hardware Setup
3
Add M.2 SATA SSD to M2D17 adapter card:
a
Insert M.2 SATA SSD into the slot. Make sure the card is fully inserted.
b
Tighten the SSD with a screw.
c
Repeat previous two steps if installing another optional SSD is needed. Slot numbers are shown as below.
4
Install the M2D17 adapter card:
a
Remove the screw that secures the adapter slot’s cover.
b
Remove the adapter slot’s cover.
c
Align the card’s connector with the adapter slot, and insert the card into the slot.
d
Put back and fasten the screw that you removed in step 4-a so as to secure the newly inserted card.
5
Put back the upper case removed in step 2 and tighten the srcews.
To Next Page
Loading...
