Synology DS220+ - Removing a Memory Module

14
Chapter 2: Hardware Setup
To remove the memory module
1
Follow step 1 and 2 of the
"To install the memory module"
section to shut down your Synology NAS,
disconnect the cables and remove the drive trays.
2
Push the levers on both sides of the memory module outward. The memory module will be released from its
slot.
3
Hold the memory module by its edges and remove it from the slot.
4
Insert the drive trays back into the drive bays.
5
Reconnect the cables removed in step 1, then press the power button to turn on your Synology NAS.