9 QSG ti-Series Laser Ver 2.5
ti-Series Laser Quick Start Guide
Things to know:
Our lasers incorporate the following wetted materials in the coolant path—nickel-plated brass, copper, Ace-
tal®, nitrile, Viton®, PBT, Delrin®, Polyethelene, and stainless steel.
Caution
Possible
Equipment
Damage
Do not exceed coolant pressure of 414 kPa (60 PSI)!
Avoid glycol-based additives because they reduce the coolant’s heat capacity and high
concentrations may aect power stability. If you must use glycol, do not add more than
10% by volume. See the Operation and/or Technical Reference sections in this Manual
for detailed information. Glycol is not necessary unless the chiller is subjected to freez-
ing temperatures.
Warning!
Serious Personal
Injury
A risk of exposure to toxic elements may result when certain optical or
beam delivery components are damaged. In the event of damage to
laser, marking head, or beam delivery optics, contact SYNRAD, or the
optics manufacturer for handling instructions.
To Next Page
Loading...
Need help?
General
