SYSMEX KX-21 - Page 124

MAINTENANCE AND SUPPLIES REPLACEMENT
Sysmex KX-21 Operator’s Manual -- Revised October 1998 4-37
8.3 Replace Printer Paper
When the "No Printer Paper" message appears on the screen, press [HELP] key and replace
printer paper by the following procedure:
*
Help
*
No Printer Paper
ERR CODE:XXXXX.X.X
Restarting to print
Stop printing on built-in printer
[1]
[3]
To make built-in printer on-line,
press [SELECT], then
[Periph. Settings]
1:Print 2:Paper Feed 3:Stop Output
Figure 4-8-3: "No Printer Paper" Message Screen
NOTE: • On the HELP screen, press
[
3
]
and select "3: Stop Output" to stop
printin
g
on built-in printer. Anal
y
sis is executed as usual but printin
g
is
not. When
y
ou want to use built-in printer a
g
ain, select "8: Periph.
Settin
g
s" to set.
(
Refer to Chapter 10, Section 9: Peripheral Settin
g
s .
)
(1) Open the front cover of the main unit.
(2) Turn the release lever up to free the paper.
Release Lever
Figure 4-8-4: Releasing the Lever
Sysmex KX-21 Operator’s Manual -- Revised January 2000