QUALITY CONTROL
Sysmex KX-21 Operator’s Manual -- Revised October 1998 5-3
4) LIMIT (UL)
The upper control limit. An analysis value exceeding this limit is a QC error.
5) LIMIT (LL)
The lower control limit. An analysis value exceeding this limit is a QC error.
6) Target value
QC Target value
7) DATA
The QC data of the plot specified by the vertical line cursor. In the case of
X
control, it
is the mean value of two consecutive analyses.
8) MEAN
The mean of QC data plotted currently
9) Line Cursor
The vertical line cursor can be moved to the right or left using [ ] key or [ ] key.
The QC data of the plot shown by the line cursor, along with analysis date, are
displayed.
To Next Page
Loading...
