QUALITY CONTROL
5-10 Sysmex KX-21 Operator’s Manual -- Revised October 1998
(4) Mix control blood sufficiently.
Figure 5-2-10: Mixing the Control Blood
(5) Remove the cap while taking care not to allow blood to scatter.
Figure 5-2-11: Removing the Cap
(6) Set the control blood container to the sample probe and press the start switch in that
status.
Start switch
Figure 5-2-12: Pressing the Start Switch
(7) When the buzzer sounds two times - beep, beep, - and "Analyzing" is displayed on the
X
Control Analysis screen, remove the control blood container. Then, automatic
analysis is executed.
To Next Page
Loading...
