SYSMEX KX-21 - Page 178

TROUBLESHOOTING
7-4 Sysmex KX-21 Operator’s Manual -- Revised October 1998
2.2 Alphabetical List of Error Messages Displayed on HELP
Screen
0.5 kg/cm
2
Pressure Error---------------------------------------------------------------------------7-7
0.5 kg/cm
2
Pressure Error at Count----------------------------------------------------------------7-9
250 mmHg Vacuum Error---------------------------------------------------------------------------7-8
[A]
Abnormal detection sensitivity--------------------------------------------------------------------7-22
[B]
Background count exceeds tolerance.------------------------------------------------------------7-17
[C]
Calibration value is out of range. ----------------------------------------------------------------7-26
Clean the SRV.-------------------------------------------------------------------------------------7-27
Clean the Transducer. ----------------------------------------------------------------------------7-29
Clean the Waste Chamber. ----------------------------------------------------------------------- 7-28
Clog in the aperture (RBC)------------------------------------------------------------------------7-15
Clog in the aperture (WBC)-----------------------------------------------------------------------7-15
[E]
Error has occurred during counting (PLT). ----------------------------------------------------7-18
Error has occurred during counting (RBC). ----------------------------------------------------7-18
Error has occurred during counting (WBC).----------------------------------------------------7-18
Error occurred during HGB analysis. -----------------------------------------------------------7-20
Error on Built-in Printer (Print Error)------------------------------------------------------------7-30
Error on Built-in Printer (Printer Error) ---------------------------------------------------------7-32
Error on Rinse Cup --------------------------------------------------------------------------------7-13
[H]
Host Output Error (When serial interface is incorporated) ------------------------------------ 7-33
[M]
Memory error occurred. (Repairing)------------------------------------------------------------7-23
Memory error occurred. (Turn OFF then ON the power.) -----------------------------------7-23
Momentary power failure occurred.--------------------------------------------------------------7-24
[N]
No Printer Paper------------------------------------------------------------------------------------7-31
[Q]
QC data falls out of control limits. ---------------------------------------------------------------7-25
[R]
Replenish Diluent Container. ---------------------------------------------------------------------7-11
Replenish Lyse Container. -----------------------------------------------------------------------7-12
Room Temp. Error --------------------------------------------------------------------------------7-16
[S]
Sampling Error has occurred. --------------------------------------------------------------------7-19
[W]
Waste Not Drained ---------------------------------------------------------------------------------7-10
WBC/HGB Analysis Error------------------------------------------------------------------------7-21