SYSMEX KX-21 - Page 179

TROUBLESHOOTING
Sysmex KX-21 Operator’s Manual -- Revised October 1998 7-5
2.3 Functional List of Error Messages
NOTE: • [ ] indicates error naming that is displayed on the Analysis screen.
1. Pressure/Vacuum Errors
0.5 kg/cm
2
Pressure Error [Pressure/Vac Error] -----------------------------------------7-7
250 mmHg Vacuum Error [Pressure/Vac Error] -----------------------------------------7-8
0.5 kg/cm
2
Pressure Error at Count [Pressure/Vac Error] -------------------------------7-9
2. Chamber Errors
Waste Not Drained [Waste Not Draining]-----------------------------------------------7-10
Replenish Diluent Container. [Replenish Diluent]-------------------------------------- 7-11
Replenish Lyse Container. [Replenish Lyse]-------------------------------------------7-12
3. Motor Errors
Error on Rinse Cup [Rinse Motor Error]------------------------------------------------7-13
4. Aperture Errors
Clog in the aperture (WBC) [WBC Aperture Clog]------------------------------------7-15
Clog in the aperture (RBC) [RBC Aperture Clog] ------------------------------------- 7-15
5. Temperature Errors
Room Temp. Error [Room Temp. High]------------------------------------------------7-16
Room Temp. Error [Room Temp. Low]------------------------------------------------7-16
6. Analysis Errors
Background count exceeds tolerance. [Background Error] --------------------------- 7-17
Error has occurred during counting. (PLT) [Sampling Error]------------------------7-18
Error has occurred during counting. (RBC) [Sampling Error] -----------------------7-18
Error has occurred during counting. (WBC) [Sampling Error]-----------------------7-18
Sampling Error has occurred. [Sampling Error]----------------------------------------7-19
Error occurred during HGB analysis. [HGB Error]-----------------------------------7-20
WBC/HGB Analysis Error [Analysis Error]--------------------------------------------7-21
Abnormal detection sensitivity [Analysis Error]----------------------------------------7-22
7. Memory Errors
Memory error occurred. (Turn OFF then ON the power.) [Memory Error]--------7-23
Memory error occurred. (Repairing) "Set Value Error]--------------------------------7-23
Memory error occurred. (Turn OFF then ON the power.) [Set Value Error] ------ 7-24
Momentary power failure occurred. [-]--------------------------------------------------7-24
8. Others
QC data falls out of control limits. [QC Error]------------------------------------------7-25
Calibration value is out of range. [Calibration Error]---------------------------------- 7-26