SYSMEX KX-21 - Page 254

INSTRUMENT SETUP
Sysmex KX-21 Operator’s Manual -- Revised October 1998 10-1
1. INTRODUCTION
Your Sysmex service representative performs the settings of the instrument at time of
installation. The settings can be changed by using this program.
This chapter describes how to use this setting program.
System Setup
Sets up the instrument system status.
Date/Time
Sets date/time of the built-in clock.
Patient Limit
Sets upper and lower Patient Mark Limits to check for error in analysis data.
QC Settings
Selects between
X
control and L-J control as the QC method, and sets the output method of
QC data.
Host Settings (when the optional serial interface is incorporated)
Sets the interface conditions for transferring data to the host computer.
Printer Settings
Sets the output selection and output conditions of the built-in printer.
Print Set Values
Prints all the contents of the settings by the built-in printer.
Peripheral Setting
Sets whether to Use or Not Use of the built-in printer or the host computer (option) output.
CAUTION: • The settin
g
pro
g
ram can be run onl
y
when the instrument is read
y
.
NOTE: • Menu selection method
(
1
)
Cursor selection
(
explained in this Manual
)
Usin
g
[ ]
or
[ ]
ke
y
, move the cursor to a desired pro
g
ram and
press
[
ENTER
]
ke
y
to set.
(
2
)
Direct ke
y
selection
Usin
g
the numeric ke
y
s, enter a menu number of the pro
g
ram
y
ou
want to set, thus selectin
g
the menu.
The menu number is displa
y
ed on the Menu screen.
• Chan
g
e set values and move the cursor to the next parameter usin
g
[ ]
or
[ ]
ke
y
([ ]
or
[ ]
ke
y
also can be used in Patient Limit settin
g)
or press
[
ENTER
]
ke
y
. This sets the settin
g
s.
Sysmex KX-21 Operator’s Manual -- Revised January 2000